#audio-io

An introduction to the 4ms Company MetaModule Audio Expander. The MetaModule Audio Expander is an audio I/O expansion module for the MetaModule. It adds 6 inputs and 8 outputs at 24bit/48kHz, connected via ribbon cable.

An introduction to the ADDAC200PI Pedal Integrator. The ADDAC200PI Pedal Integrator is a utility module that attenuates modular output to line level suitable for effect pedals and amplifies the return signal back to modular level. It also features 3.5mm/6.35mm jack conversion, providing a simple bridge between modular and external gear.

An introduction to the ADDAC200S Size Matter. The ADDAC200S Size Matter is a utility module that handles 6.35mm and 3.5mm jack conversion in a single unit. It features 3 pairs of passive conversion channels, requires no power, and is easy to install. Compatible with external effects and audio interfaces.

An introduction to the ADDAC219IN Stereo > Dual Mono. The ADDAC219IN Stereo > Dual Mono is an interface module that separates external line-level stereo signals into individual left and right mono outputs. It accepts a 3.5mm stereo TRS jack input, internally splits the signal into left and right mono, and outputs each through independent 3.5mm mono output jacks. It also boosts line-level signals to Eurorack level. With two conversion sections, this module serves as a bridge between external gear and your Eurorack system.

An introduction to the ADDAC219OUT Dual Mono > Stereo. The ADDAC219OUT Dual Mono > Stereo is a passive 3HP module that provides a simple way to send signals from your Eurorack system to external stereo gear. It combines two mono inputs (left/right) into a single TRS stereo output, attenuates the modular synth level down to line level, and outputs through a 3.5mm TRS stereo jack. With three independent sections, it can send multiple outputs to external gear at once.

An introduction to the AI Synthesis AI026 Line I/O Interface. The AI026 Eurorack Line Interface converts between line-level signals (approximately +/-2V) and the signal levels commonly used by Eurorack modules (approximately +/-5V). This allows you to boost low-voltage line-level signals to standard modular synth levels, or perform the reverse.

An introduction to the ADDAC712 Vintage Pre. The ADDAC712 Vintage Pre is a dual-channel discrete gain stage amplifier based on a famous discrete preamp board used in legendary equipment from the 1970s. In short, it produces a pleasing saturation/distortion effect.

An introduction to the NoisyFruitsLab VU Level Meter. The VU Level Meter is a module that recreates a classic analog level meter using LEDs.

An introduction to the Meng Qi Pe2. The Pe2 is a passive transformer module that converts between balanced and unbalanced connections, equipped with a ground lift switch.